[. . . ] Should you remove screws, cord clamps, or stabilizer, make sure to put them in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. When putting the Pedal Board on the stabilizer, first loosen the attachment screws securing the speaker box to the side boards. [. . . ] When putting the Pedal Board on the stabilizer, first loosen the attachment screws securing the speaker box to the side boards. Connect the speaker cable extending from the rear of the speaker box to the CS-10's speaker connector. Before you begin assembling the CS-10, check that all the parts were supplied. When securing the screws, lay the entire unit sideways with the rear side of the CS-10 at the bottom. Secure the left side board to the speaker box with the attachment screws (in two places). attach so that the speaker cable at the rear of the speaker box is directed to the right. Take care not to attach the left and right stabilizer to the wrong sides. Fasten the piano to the stand with the attachment screw (M6 x 20 mm) (one each for the right and left). Please don't get your fingers pinched Disassemble the unit by carrying out assembly Steps 111 in reverse order. At first, assemble the entire unit in a temporary fashion, without really tightening the screws. Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws. When standing the assembled unit up, grasp near the speaker box, and gently raise the assembly. [. . . ] Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws. When standing the assembled unit up, grasp near the speaker box, and gently raise the assembly. [. . . ]